Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3
Volvo Tech Tool 2.6.60 download
with free remote installation and activation help
Follow these instructions (src: http://www.premiumtechtool.com/) only if you downloaded the driver from the website.
Locate the saved file and extract the file contents.
Open the folder and Install (double click) the file.
On your PC, go to Start, All Programs. Click on VOCOM II folder and then click to launch the VOCOM II Configuration Application.
Plug the VOCOM II into the PC USB port. The VOCOM II will display under “All devices”
Please note: Serial Number (SN) differs. Do not connect to the vehicle at this time
When you receive the “Please update device firmware” pop up message. Click the to continue.
Click “Update device”.
The software will begin to update.
Note: Updating device can take a few minutes.
When the Update is complete. The VOCOM Configurator will refresh the settings.
Open Premium Tech Tool 2.6 and go to “Settings” to configure the adapter settings.
Here you can select the VOCOM II and then “Activate” to enable. Next, click OK to close window.
Please note: VOCOM I (88890300) and VOCOM II (88894000) use different drivers and must be activated separately
You’re now ready to connect to a vehicle!
This article tech Supported by China OBD2,
|Free forum by Nabble||Edit this page|